DIN 3055 Steel wire rope

 DIN 3055 is a steel tensile rope, which is a rigging accessory made of connected strands. The DIN 3055 tension rope was given this name because it is used to stretch elements. A spire or antenna fixed by the tensile method is not subject to tilting or falling if the strength of the rope is sufficient for the load that occurs.

DIN 3055 fastening group

     Ropes of DIN 3055 standard belong to the stainless steel anchoring group

Materials of manufacture of DIN 3055 steel cables

     DIN 3055 is manufactured in the following materials:

• Steel, which can optionally be coated with zinc
• Stainless steel (A2, A4) does not require coating

Application of medium soft ropes DIN 3055

     A tension rope of DIN 3055 standard is used for the installation of television towers, antennas, and remote signal transmission devices. It is also widely used for fixing high-voltage lines to increase the strength of fixation. With a run of more than 100 meters, it is necessary to mount a cable fixed around the high-frequency line between the transmitters and the receiver. And when moving through the sections, a galvanized rope and power transmission cable are fixed. In this case, the load is taken by the rope, which has a safety margin.

     In addition, the scope of application directly depends on the material of manufacture and coating of the product:

• Galvanized steel offers good corrosion protection if the fastener is to be used in aggressive environments.
• Stainless steel allows the fasteners to be used at significant temperature fluctuations and in aggressive and humid environments.